Logo

U2645 Engine Trouble Code

Meaning of U2645 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U2645 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U2645 code is occuring now you should check U2645 repair processes.
Now don't ask yourself; What should you do with U2645 code ?
The solution is here :

U2645 Possible Solution:

U2645 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

U2645 Code Meaning :

U 2 6 4 5
OBD-II Diagnostic Network (U) Trouble Code For Engine Fuel And Air Metering (Injector Circuit Malfunctions Only) Fuel Temperature Sensor B Circuit Range/Performance Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector) Crankshaft Position Sensor B Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U2645 OBD-II Diagnostic Network (U) Trouble Code Description

U2645 engine trouble code is about Crankshaft Position Sensor B Circuit Malfunction.

Main reason For U2645 Code

The reason of U2645 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance.

U2645 DTC reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.